We’ll need to take the washing machine to a locksmith. From what I can see, it seems like you can remove the tumbler from the back of the lock, which is probably a hardware store-related issue. I’m afraid something may have come loose in the keyhole, and the key won’t go in. If you think this is the core problem, you can use a wire. It usually points to either having an odd-shaped key or an incorrectly placed blade. If it’s hard to move and sticks on one side of the slot, then it might just be a problem with the shape of the key. If the lock is behaving strangely, turn the key back and forth a few times. There is more than one type of lock on coin-operated appliances, and if you find a way to make the pressing enter (shifting some tumblers), it indicates that it is an old lock. Did you ever notice that the keyhole is sometimes a little hard to insert a key?Ī close-up photo of the keyhole would be beneficial. If your tenants need to pay for the use of your machine, they might also need a key to open it. The unit has been running cold for a while now, and it appears the fix was to replace the control board. That’s the only thing that would make it act like that unless there is a wiring fault.įixing the control board has corrected the issue. I think I meant to say the control board when I said panel. To test, you should unplug it and use a multi-meter to check continuity on either side of the heating element. When troubleshooting an electric dryer, the base thing to look at is the heating element. The heat is on all of the time because of a shorted heating element, and because finally, there’s also a lousy wiring connection to the heating element. I ran it for 1 minute, and the dryer was boiling.

The thermal fuse that keeps blowing is Thermal Fuse 339 SER MY2610635. Whenever I vacuum my dryer, the thermal fuse always blows. It worked one cycle, and the thermal fuse blew again. I replaced it two times then replaced the thermistor. Then it took about 7 minutes for my machine to reset. It might still come up with an error, but the problem should be there if not. Check for continuity on both ribbon cables and thoroughly test the control panel.

The display board may have a faulty interface panel based on your description. Also, I would check all harness wires and connectors between those spots. In that case, we need to check all the options. I have replaced the control panel and the main control board, and neither fixes the problem. The dryer’s control lock is locked (won’t start). The dryer was constantly beeping and turning on by itself from time to time, but it still runs. The Whirlpool dryer calypso touchpad stopped working. Whirlpool duet dryer control locked reset 5 Replace the control lock of the dryer.1 Whirlpool duet dryer control locked reset.

Whirlpool duet dryer thermal fuse